PTZ Camera Wireless Video Transmitter Kit

  • 2.4GHz Wireless Video Kit
  • Transmits Analog Resolution Video
  • Transmits RS485 Controls
  • Description

    2.4GHz Digital Wireless Video and RS485 Data Transmitter Set that will allow you turn any analog PTZ camera in to a wireless PTZ camera. This kit is compatible with Pan Tilt Zoom cameras that are Pelco-D protocol compatible. There aren’t many products of this kind that can transmit video, audio, and PTZ controls at the same time, and let the user send commands back through the receiver using a PTZ joystick.

    This PTZ transmitter and receiver set will transmit a signal up to 300ft away using the included antennas in clear line of sight, and signal can be amplified up to 1000ft using the 2.4GHz High Gain Panel Antenna on both the transmitter and receiver. Keep in mind that wireless transmission is best with line of sight and you can always use a high gain antenna to boost your signal to run the signal farther.

    The transmitter and receiver are small in size, approximately 5 inches in width and length and 2 inches tall, and light weight. The digital wireless frequency hopping technology allows multiple PTZ wireless kits to be used in one location. We suggest no more than 4.

    If you are looking for a good enclosure to house these units, then try our outdoor weather proof enclosure.

    Below is a useful overview video discussing on how to use this PTZ wireless transmitter kit, and see an actual demonstration of what you can expect from the video quality.

    What’s included?

    • (1) 2.4GHz Audio/Video/Data Transmitter
    • (1) 2.4GHz Audio/Video/Data Receiver
    • (2) Power Supplies
    • (2) 3dbi Antennas

    Specifications

    Frequency 2400-2480 MHz, 25-CH Auto Hopping
    (FCC & CE RTTE)
    RF TX Power 100mW (Average) No
    Modulation 16-QAM,Q PSK,BPSK
    Min. RX Sensitivity No -80 dBM
    Video
    Video Compression MPEG-4
    Max. Frame Rate vs. Resolution NTSC: 30fps at 720 x 480 (D1) 
    Bit Rate Up to 6Mbps
    Audio
    Sampling Rate 48KHz, Stereo
    S/N Ratio 63dB
    Data
    RS485 2-wire RS485 Half Duplex Baud Rate: 
    2400/4800/9600 bps
    Fixed Formats: 1 Start bit, 1 Stop bit, 8 Data Bits, 
    No Parity 120?Termination Resistor 
    ON/OFF Setting
    LED Indicators
    Red LED Power On and RF Link Status
    Green LED RS-485 Data Link Status
    Mechanical & Environmental
    Power Consumption 230mA @ 12VDC
    Operation Temperature -10°C~50°C
    Storage Temperature -30°C~85°C

    FILL YOUR QUERY

    Thank you